Step 1: Locate and Remove the Control Panel
First, locate the window controller control panel inside the door, usually located at the front or rear of the door armrest. Use a screwdriver and wrench to remove the screws securing the control panel; these screws are typically 10mm. After removing the screws, carefully pry open the control panel cover to separate it from the door lining.
Step 2: Remove the Screws and Wire Connectors on the Window Controller Motor
Next, locate and remove the screws on the window controller motor. This screw is usually located at the bottom of the motor. After removing the screws, disconnect the wire connectors connected to the motor. These connectors are usually plug-in type; simply pull them back gently to disconnect. At this point, the entire window controller switch has been removed.
Step 3: Handle the Interior Trim Panel and Fixing Screws
During the disassembly process, you may also encounter fixing screws on the interior trim panel. These screws are usually located on the door handle, armrest, panel edges, etc. Use a screwdriver to remove these screws one by one and carefully remove the interior trim panel, being careful not to pull on the connecting wiring harness.
